Allow for large part previews even after nesting (Beta Tester Suggestion)
Rob Hellier
started a topic
over 6 years ago
Once you've imported DXF's, in the list of parts, when you click on them they show in large shapes in the lower window. But once you start nesting, you can't get them to show largely. They only show as small parts on the nested sheet.
Assume that the nest is not going well. The parts aren't fitting. Now, I'm done with that nest. I wish it could be cleared from the screen. Because when I'm trying to recalculate the number of parts to nest for another try, I want to see them in full size again so I can tell which is which. Many parts are very similar in features and need to be seen clearly to differentiate. Currently, you have to look at them as small bits and pieces on a defunct nested sheet.
Rob Hellier
Once you've imported DXF's, in the list of parts, when you click on them they show in large shapes in the lower window. But once you start nesting, you can't get them to show largely. They only show as small parts on the nested sheet.
Assume that the nest is not going well. The parts aren't fitting. Now, I'm done with that nest. I wish it could be cleared from the screen. Because when I'm trying to recalculate the number of parts to nest for another try, I want to see them in full size again so I can tell which is which. Many parts are very similar in features and need to be seen clearly to differentiate. Currently, you have to look at them as small bits and pieces on a defunct nested sheet.